This method is for fully cooked spiral ham packaged in a USDA-inspected plant. It is not for raw, cook-before-eating, or repackaged ham, or for reheating leftovers. Fit the removable roasting pan into the roaster. For this recipe, add 2–4 cups of water to the removable pan, about 1/4 inch deep. Never pour liquid directly into the electrical roaster body. Follow the ham’s package heating directions and your roaster manual. Preheat to 275°F only if both allow that setting for this ham.
Lay 2-3 sheets of heavy duty aluminum foil on a countertop or work surface, overlapping the edges. Use enough foil to cover the entire ham.
Remove the ham from its packaging, reserving any juices. Lay the ham on the aluminum foil on its side, with the cut side facing you.
Lift the foil and wrap it around the ham, leaving the top open.
Using oven mitts, position the roasting rack and wrapped ham in the removable roasting pan. Pour any reserved packaging juices over the ham.
If using an oven-safe leave-in probe thermometer, insert it into the thickest part of the ham, away from bone. Keep the display outside the roaster and route the cable according to the thermometer's instructions, away from heating elements and without pinching it under the lid. An instant-read thermometer is for spot checks only; remove it after each reading. Wrap the foil tightly, leaving it easy to reopen.
Close the roaster lid and maintain the setting specified by the ham’s package directions. For this fully cooked, plant-packaged ham, the final internal temperature is 140°F.
Heat the ham to an internal temperature of 100°F, then begin glazing. Meanwhile, make the glaze. If the ham’s package directions and your roaster manual allow 275°F, allow roughly 15–20 minutes per pound as a planning estimate (about 2 hours to 2 hours 40 minutes for an eight-pound ham). Timing varies with ham size, starting temperature, and roaster model. Use the thermometer and package directions rather than the clock.
Combine all glaze ingredients in a small saucepan, and bring to a boil over medium high heat. Boil glaze for 2 minutes.
At an internal temperature of 100°F, open the foil and pour two-thirds of the glaze over the ham.
Re-wrap the ham and continue heating until it reaches an internal temperature of 120°F.
Using a pastry brush, brush the remaining glaze over the ham. Re-wrap and continue heating according to the ham’s package directions until the thickest part reaches 140°F.
Optional: Only if your roaster's manual permits 425°F, open the foil, replace the lid, and heat at 425°F for about 10 minutes to caramelize the glaze. Watch closely; this extra step may dry the ham slightly.